DHCP setups vary according to the percentage of total sets that you want to record.
To record… |
You can use this DHCP setup… |
A small percentage of total sets |
Configure the phones manually as teleworker phones and enter the IP address of the MBG/SRC server when prompted for the Teleworker Gateway IP address. For more information, refer to the MBG Remote Phone Configuration Guide available at Mitel OnLine. |
A large percentage of total sets |
A possible setup for this scenario is to deploy the recorded group on a different subnet from the non-recorded phones. You can use the MiVoice Business/3300 ICP as the DHCP server for the non-recorded phones and the MSL server as the DHCP server for the recorded phones subnet. The recorded phones will then receive the IP address of the MBG/SRC server as their Call Server (ICP) and TFTP addresses. |
All sets |
Configure the DHCP server in your MiVoice Business/3300 ICP to supply the IP address of the MBG/SRC server to the phones as their ICP and TFTP addresses OR Enable the pre-configured DHCP server supplied with the MSL server. |
For more information about configuring DHCP in the MSL server, refer to the "Configuring the Server" section of the Mitel Standard Linux Installation and Administration Guide.