Allow ICMP, SSH and HTTPS access to Service Node IP address

Azure blocks incoming traffic, so to be able to access the MX-ONE VM via SSH after the initial setup, the following needs to be done.

  1. Go to Networking and click Add inbound rule.

    inset_22.jpg

  2. Add the SSH rule with the proper information of the network, so that your local computer can access the MX-ONE in Azure. The below is just an example.
    Note: It is a best practice to define the specific network in the Source IP Addresses/CIDR ranges.

    ;

  3. MX-ONE requires ICMP in the subnet during installation and for some functions, so an ICMP rule needs to be added.

    inset_24.jpg

  4. Repeat the same procedure to create rules for HTTPS (PM and SNM) and SIP/TLS (5061) SIP/VDP (22226) and SIP/XML (22223).
    Note: Any type of traffic that needs to be directed to MX-ONE or any application in Azure requires a rule. This is not covered in this document, so for additional information regarding MX-ONE TCP/UDP/SCTP ports read the MX-ONE document called “MiVoice MX-ONE System Planning – Description”, chapter 13 IP Protocols and Ports.
Parent topic: Create the MX-ONE VM and Additional Setup
↑