Configure Mailbox Passcode Parameters by Line Group
This procedure describes how to:
-
Set a minimum and maximum passcode length
-
Set the number of incorrect passcode attempts that will trigger a warning
-
Set the period for counting incorrect passcode attempts
To configure mailbox passcode parameters by line group:
-
From the Main Menu, select (S) System Maintenance, (R) Reconfiguration, and then (R) Reconfigure System.
-
Do one of the following:
-
Select (F) Modify Inactive Configuration if you just made a change through the Offline Menu without activating it
-
Otherwise, select (E) Modify Active Configuration.
-
Select (G) Group Selected and enter the number of the line group (1-24) that you want to modify.
-
Select (M) Modify Application and then (P) Passcode Menu.
-
Select (M) Minimum Passcode Length and enter a number (4-10). This is the minimum number of digits that constitute a valid passcode for all users in the current line group.
-
Select (N) Maximum Passcode Length and enter a number (4-10). This is the maximum number of digits that constitute a valid passcode for all users in the current line group.
-
Select (C) Passcode Trip Count and enter the number of times (1-255) someone can attempt to use an incorrect passcode during a passcode trip period before a warning is issued, or enter 0 (zero) to disable the passcode trip count function.
-
Select (P) Passcode Trip Period and enter the number of hours (1-240) for the time limit for a passcode trip count, or enter 0 (zero) to disable the passcode trip period function.
-
Save the parameter settings by exiting to the NuPoint Voice Configuration Main Menu.
-
If you chose to modify the Inactive Configuration in step 2, you need to Activate the Inactive Configuration before your changes appear.